1. | Disconnect the negative (-) battery terminal. |
2. | Remove the driver airbag module. (Refer to the RT group) |
3. | Remove the steering wheel. (Refer to the ST group - "Steering column & shaft") |
4. | Remove the steering wheel cover
(A) after loosening the screws.
|
5. | Remove the steering wheel remote
control switch connector (A) after loosening the mounting screws. [LH-Mute]
|
Parking Brake and Brake Fluid Warning
Parking Brake Warning
This light comes ON when the parking brake is applied with the ignition switch
in the START or ON position. The warning light should go off when the parking brake
is release ...
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet
its seal with engine coolant, and then install it on a pressure tester.
2.
Apply a pressure of 93.16 ~ 122.58k ...
Installation
1.
Install the wiper switch.
2.
Install the steering column upper
and lower shrouds.
...