1. | Remove the shift lever knob. (Refer to the BD group - "Console") |
2. | Remove the console upper cover
(A).
|
3. | Disconnect the connector from the console upper cover. |
4. | Remove the multimedia jack (B)
from the console under cover after releasing the fixed hooks (A).
|
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection ProcedureMeasuring Condition of Electronic Parts' Resistance
The measured resistance at hi ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is found, repa ...
Inspection
Speed Operation Check
1.
Remove the connector (A) from
the wiper motor.
NO
Description
NO
Description
...