1. | Disconnect the negative (-) battery terminal. |
2. | Remove the steering wheel. (Refer to the ST group - "Steering column & shaft") |
3. | Remove the steering column upper
and lower shrouds after removing 3 screws.
|
4. | If it is necessary to remove.
The wiper & washer switch (A) only, release the lock of wiper switch using
tool without removing the steering wheel and the clock spring.
|
5. | Disconnect the lighting switch
connector (A) and wiper & washer switch connector (B).
|
6. | Remove the steering wheel. (Refer to the ST group - "Steering column & shaft") |
7. | Remove the clock spring. (Refer to the RT group - "Airbag module") |
8. | Remove the multifunction switch
assembly (A) after loosening the mounting screws.
|
Illuminated ENGINE START/STOP button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience. The light will go off after about 30 seconds when the door
is closed. It will also go off im ...
Trunk Room Light Bulb Replacement
1. Remove the trunk room lamp cover using flat blade screw driver.
2. After replacement of bulb, install the cover. ...
Inspection
1.
Check that the red light flickers
when the door lock or unlock button is pressed on the transmitter.
2.
Remove the battery (A) and check
voltage if the red light d ...