Kia Optima: Removal
1. |
Remove the front wheel and tire.
Tightening torque:88.3
~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
|
|
2. |
Remove the front wheel speed
sensor mounting bolt (A).
Tightening torque:7.8 ~
9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
3. |
Remove the front wheel guard
. |
4. |
Remove the front wheel speed
sensor cable mounting bolt. |
5. |
Disconnect the front wheel speed
sensor connector, then remove the front wheel speed sensor. |
6. |
Installation is the reverse of
removal. |
1.
Measure the output voltage between
the terminal of the wheel speed sensor and the body ground.
...
See also:
Engine compartment
2.4L Engine
2.0L Engine
* The actual engine room in the vehicle may differ from the illustration.
1. Engine coolant reservoir
2. Engine oil filler cap
3. Brake/clutch fluid reservoir
...
Removal
Side Repeater Lamp
1.
Disconnect the negative (-) battery
terminal.
2.
Open the front door.
3.
Remove the side repeater lamp
assembly by using the a fl ...
Repair procedures
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the throttle body
and connect a vacuum pump to the nipple on the throttle body.
2.
Chec ...