Kia Optima: Removal
| 1. |
Turn the ignition switch OFF. |
| 2. |
Remove the air duct (B) and air
cleaner assembly (A).
|
| 3. |
Remove the ECM connector (B)
and the arrange the wiring harness (A).
|
| 4. |
Pull up the lock of the HECU
connector (A) , then disconnect the connector.
|
| 5. |
Remove the brake fluid from the
master cylinder reservoir with a syringe.
| •
|
Be sure to completely
remove foreign substances from around brake fluid reservoir
and cap before opening the reservoir cap. If not, it may
cause contamination of brake fluid and deterioration in
braking performance. |
| •
|
Do not spill
brake fluid on the vehicle, it may damage the paint; if
brake fluid does contact the paint, wash it off immediately
with water. |
|
|
| 6. |
Disconnect the brake tubes from
the HECU by unlocking the nuts counterclockwise with a spanner.
Tightening torque:M10:
11.7 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)
M12: 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)
|
|
| 7. |
Loosen the HECU bracket bolts
(A), then remove HECU and bracket.
Tightening torque :19.6
~ 29.4 N.m(2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
|
| 1. |
Never attempt
to disassemble the HECU. |
|
|
| 8. |
Remove the 2 nuts (B), then remove
the bracket from HECU.
Tightening torque :10.8
~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)
|
|
1.
Installation is the reverse of
removal.
2.
Tighten the HECU mounting bolts
and nuts to the specified torque.
3.
After installation, bleed the
b ...
See also:
Mode selection
The mode selection button controls the direction of the air flow through the
ventilation system.
Every time you press the mode selection button, the mode will change as follows:
Refer to the i ...
Changing the Engine Oil and Filter
Change engine oil and filter according to the Scheduled Maintenance at the beginning
of this section.
WARNING - Engine Oil
Continuous contact with USED engine oil has caused skin cancer in la ...
Passenger And Rear Power Window Switch
...
Installation