Kia Optima: Removal
1. |
Turn ignition switch OFF and
disconnect the negative (-) battery cable. |
2. |
Remove the air duct (B) and air
cleaner assembly (A).
|
3. |
Disconnect the brake fluid level
switch connector (A), and remove the reservoir cap.
|
4. |
Remove the brake fluid from the
master cylinder reservoir with a syringe.
•
|
Be sure to completely
remove foreign substances from around brake fluid reservoir
and cap before opening the reservoir cap. If not, it may
cause contamination of brake fluid and deterioration in
braking performance. |
•
|
Do not spill
brake fluid on the vehicle, it may damage the paint; if
brake fluid does contact the paint, wash it off immediately
with water. |
|
|
5. |
Disconnect the brake tube (A)
from the master cylinder by loosening the tube flare nut.
Tightening torque:18.6
~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)
|
|
6. |
Remove the master cylinder from
the brake booster after loosening the mounting nuts (A).
Tightening torque:12.7
~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
|
|
1.
Installation is the reverse of
removal.
2.
After installation, bleed the
brake system. (Refer to Brake system bleeding)
...
See also:
Sunglass Holder
A compartment is provided at the overhead console to store sunglasses. To open
the sunglass holder, press the cover and the holder will slowly open. Place your
sunglasses in the compartment door ...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
Checking the coolant level
WARNING
Removing radiator
cap
Never attempt to remove the radiator
cap while the engine is operating
or hot. Doing so might lead
to cooling system and engine
damage. Also, hot ...