1. | Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
2. | Remove the driver airbag module
from the steering wheel after pressing the snap fit pin stopper.
|
3. | Remove the wiring fixing clip(C)
and disconnect the horn connector (A).
|
4. | Release the connector locking
pin, then disconnect the driver airbag module connector(B).
|
5. | Remove the steering wheel and
steering wheel column shroud. (Refer to the Steering System group- Steering
Column and Shaft)
|
6. | Disconnect the clock spring and
horn connector, then remove the clock spring.
|
CD Player : PA710TFU
❋There will be no logo if the Bluetooth® wireless technology feature is not supported. ...
Installation
1.
Installation is the reverse of
removal.
After replacement or reinstallation procedure of the valve body assembly, ...
Heating and air conditioning
1. Start the engine.
2. Set the mode to the desired position. To improve the effectiveness of heating
and cooling :
- Heating: - Cooling:
3. Set the temperature control to the desired position.
...