Kia Optima: Removal
| • |
Removal of the airbag
must be performed according to the precautions/ procedures described
previously. |
| • |
Before disconnecting
the front impact sensor connector, disconnect the front airbag connector(s). |
| • |
Do not turn the ignition
switch ON and do not connect the battery cable while replacing the
front impact sensor. |
|
| 1. |
Disconnect the battery negative
cable, and wait for at least three minutes before beginning work. |
| 2. |
Remove the air duct (A).
|
| 3. |
Loosen the radiator upper hose
bolt (A).
|
| 4. |
Remove the radiator mounting
bracket (B).
|
| 5. |
Disconnect the front impact sensor
connector (A).
|
| 6. |
Loosen the front impact sensor
mounting nut (B) and remove the front impact sensor. |
•
Do not turn the ignition
switch ON and do not contact the battery cable while replacing the
front impact s ...
See also:
ENGINE START/STOP button position
OFF
Not illuminated
• With automatic transaxle
To turn off the engine (START/RUN position) or vehicle power (ON position), press
the ENGINE START/STOP button with the shift lever in the P (Park ...
Reassembly
•
Thoroughly clean all
parts to assembled.
•
Before installing the
parts, apply ...
Checking the Manual Transaxle Oil Level
1. Raise and suitably support the vehicle.
WARNING - Lifting Your Vehicle
If you raise your vehicle, always ensure that it is supported at all four jacking
or lift points for the vehicle. Do ...
Installation