Kia Optima: Removal
1. |
Remove the rear wheel & tire.
Tightening torque:88.3
~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
|
Be careful not to damage the hub bolts when removing the rear wheel
& tire. |
|
2. |
Loosen the bolt & nut and then
remove the rear upper arm (A) with the rear axle.
Tightening torque:137.3~156.9N.m(14.0~16.0Kgf.m,
101.3~115.7lb-ft)
|
|
3. |
Set up the transmission jack
(A) under the lower arm (B).
|
4. |
Loosen the bolt & nut and then
remove the rear upper arm (A) with the rear axle.
Tightening torque:137.3~156.9N.m(14.0~16.0Kgf.m,
101.3~115.7lb-ft)
|
•
|
When removing
the bolt, remove the upper arm in no-load condition by using
the transmission jack. |
|
|
5. |
Loosen the bolt & nut and then
remove the rear upper arm (A) with the sub frame.
Tightening torque:156.9~176.5N.m(16.0~18.0Kgf.m,
115.7~130.2lb-ft)
|
•
|
When removing
the bolt, remove the upper arm in no-load condition by using
the transmission jack. |
|
|
1.
Installation is the reverse of
removal.
•
If you don't
...
See also:
Adjusting the height of front seat cushion
Front height of front seat cushion
Move the front portion of the control knob up to raise or down to lower the front
part of the seat cushion.
Rear height of front seat cushion
Move the rear ...
To decrease the cruising speed
Follow either of these procedures:
Move the lever (1) down (to SET-) and hold it. Your vehicle will gradually
slow down. Release the lever at the speed you want to maintain.
Move the lever ...
Components and Components Location
Component Location
1. Start Stop Button(SSB)
2. FOB key holder
3. FOB key
4. Trunk lid open switch
5. Smart key unit
6. RF receiver
7. Body control module
...