Kia Optima: Removal - Line Pressure Control Solenoid Vale. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Optima TF 2011-2024 Service ManualKia Optima: Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly. (Refer to "Valve Body" in this group)

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between sensor signal terminal and sensor g ...

35R Clutch Control Solenoid Valve(35R/C_VFS). Description and Operation
Description 35R clutch control solenoid valve(35R/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 35R clutch. ...

See also:

Satellite radio reception
Satellite radio reception You may experience difficulties in receiving SIRIUS® satellite radio signals in the following situations. If you are driving in a tunnel or a covered parking area. ...

Adjustment
Stop lamp switch clearance adjustment If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below. 1. Disconnect the stop lamp switch ...

Removal
Parking Brake Pedal [Foot type] 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel and reinforcing panel. (Refer t ...

Copyright © www.kiopman.com 2024