Kia Optima: Removal
1. |
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.) |
2. |
Remove the under cover (A).
Tightening torque:7.8 ~
11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
3. |
Replace new gasket and the plug
after draining the automatic transaxle fluid by removing the drain plug.
(Refer to "Hydraulic system (Fluid)" in this group) |
4. |
Remove the valve body cover (B)
and eyebolt (A).
Tightening torque:(A) 34.3
~ 44.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~ 32.6 lb-ft)
(B) 13.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.8 lb-ft)
|
Always replace the gasket of the eyebolt use new one whenever loosening
eyebolt. |
|
5. |
Disconnect the oil temperature
sensor connector (A).
|
6. |
Remove the oil temperature sensor
(A) after removing a bolt.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
1.
Installation is the reverse of
removal.
After replacement or reinstallation procedure of the valve body assembly, ...
See also:
Dome Light
The dome light switch, located in the light assembly, has three positions:
OFF - The light stays off even when a door is open.
DOOR - The light turns on or off when a door is opened or closed.
ON ...
Disassembly
1.
Remove the dust packing & cap
(A) from the pinion housing.
2.
Loosen the lock nut and then
remove the tie rod end (B) and lock nut (A) from the tie rod ...
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the main crash pad lower
cover (A).
3.
Disconnect the blower resistor
connector ...