Kia Optima: Removal
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable. |
2. |
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
When removing the fuel pump relay, a Diagnostic
Trouble Code (DTC) may occur. Delete the code with the GDS after
completion of “Release Residual Pressure in Fuel Line” work. |
|
3. |
Remove the intake manifold (Refer to “Intake And
Exhaust System” in EM group). |
4. |
Disconnect the rail pressure sensor connector (A),
and then remove the sensor (B) from the delivery pipe.
|
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and
various engine speed.
Condition
...
•
Install the component with the specified
torques.
•
Note that internal damag ...
See also:
Tire and loading information label
The label located on the driver's door
sill gives the original tire size, cold
tire pressures recommended for your
vehicle, the number of people that
can be in your vehicle and vehic ...
Self-diagnosis
If you don’t hear an audible warning sound or if the buzzer sounds intermittently
when shifting the gear to the R (Reverse) position, this may indicate a malfunction
in the rear parking assist sys ...
Gasoline containing alcohol and methanol
Gasohol, a mixture of gasoline and ethanol (also known as grain alcohol), and
gasoline or gasohol containing methanol (also known as wood alcohol) are being marketed
along with or instead of leade ...