Kia Optima: Reassembly
Thoroughly clean all parts to be assembled. Before installing the parts,
apply fresh engine oil to all sliding and rotating surfaces.
Replace oil seals with new ones. |
1. |
Install valves.
(1) |
Using SST(09222-4A000),
push in a new oil seal.
Do not reuse old valve stem seals. Incorrect installation
of the seal could result in oil leakage past the valve guides.
|
|
(2) |
Install the valve, valve
spring and spring retainer.
Place valve springs so that the side coated with enamel
faces toward the valve spring retainer and then installs
the retainer. |
|
(3) |
Using the SST(09222-3K000,
09222-3K100), compress the spring and install the retainer locks.
After installing the valves, ensure that the retainer locks are
correctly in place before releasing the valve spring compressor.
|
(4) |
Lightly tap the end of
each valve stem two or three times with the wooden handle of a hammer
to ensure proper seating of the valve and retainer lock. |
|
2. |
Install the MLAs after appling
engine oil. Check that the MLA rotates smoothly by hand.
MLA can be reinstalled in its original position. However, the
valve lash clearances must be rechecked and adjusted accordingly
before the cylinder head is installed onto the cylinder block.
Refer to General information in EM section for Valve Clearance checking
and adjustment procedure. |
|
Cylinder Head
1.
Inspect for flatness.Using
a precision straight edge and feeler gauge, measure the surface the contacting
the cylinder block and the manifolds for warpage.
...
•
Thoroughly clean all
parts to be assembled.
•
Always use a new head
and mani ...
See also:
Circuit Diagram - ESC (3)
...
Repair procedures
Adjustment
TCM Learning
When shift shock is occurred or parts related with the transaxle are replaced, TCM
learning should be performed.
In the following case, TCM learning is requir ...
General Safety Information and Caution
Instructions
When Handling Refrigerant
1.
R-134a liquid refrigerant is
highly volatile. A drop on the skin of your hand could result in localized
frostbite. When handling the refrige ...