Kia Optima: Reassembly
1. |
Wrap tape around the driveshaft
spline(TJ) to prevent damage to the boots. |
2. |
Apply grease to the joint boot
on the side of the wheel and install the boot.
Lubricants Quantity:GRB006
(UREA) 105g (3.7 OZ.)
|
|
3. |
Using the SST (09495-3K000),
secure the boot band.
Clearance (A): 2.0 mm (0.079
in) or less
|
|
4. |
To install the dynamic damper
(A), keep the shaft in a straight line and assemble the dynamic damper with
the bands(B).
|
5. |
Assemble the transaxle side joint
boot and bands. |
6. |
Using the alignment marks (D)
made during disassembly as a guide, install the spider assembly (A) and
snap ring (B) on the driveshaft splines (C).
Lubricants Quantity:SH06-VX21
(UREA) 145g (5.1 OZ.)
|
|
7. |
Add specified grease to the joint
boot as much as it was wiped away at inspection. |
8. |
Install the both boot band. |
•
Do not disassemble the
BJ assembly.
•
Special grease must be
applied to the d ...
See also:
Fuses
A vehicle’s electrical system is protected
from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located
in the driver’s side panel bolster, the
other in the engin ...
Components
1. Heater Case (LH)
2. Separator
3. Evaporator Core
4. Shower Duct
5. Heater Core Cover
6. Heater Core
7. Mode Actuator
8. Mode Cam
9. Temp Actua ...
Interior Trim. Components and Components Location
Components
1. Front pillar trim
2. Center pillar upper trim
3. Center pillar lower trim
4. Rear pillar trim
5. Cowl side trim
6. Front door scuff trim
7. Rea ...