Inspection
Power Seat Motor1. | Disconnect the connectors for
each motor. A : Front height motor B : Slide motorC : Rear height motor D : Recline motorE : Lumber support motor
|
2. | With the battery connected directly to the motor terminals, check if the motors run smoothly. |
3. | Reverse the connections and check that the motor rotates in reverse. |
4. | If there is an abnormality, replace
the motors.
|
1. | Disconnect the limit switch and operate the limit switch. |
2. | Check for continuity between the terminals. |
3. | Make sure that the seat operation is normal in the reverse after the maximum operation. |
4. | If there is an abnormality, replace
the limit switch.
|
Inspection
1.
Measure the pressure of high
pressure line by measuring voltage output between NO.1 and NO.2 terminals.
2.
Inspect the voltage value whether
it is sufficie ...
Installation
1.
Install the multimedia jack.
2.
Connect the multimedia jack connector.
3.
Install the console upper cover.
4.
Install the shift lever knob. ...
Removal
Pressure Side Impact Sensor
•
Removal of the airbag
must be performed according to the precautions/pr ...