Inspection
Front Door Lock Actuator Inspection1. | Remove the front door trim. (Refer to the BD group - "Front door") |
2. | Remove the front door module. |
3. | Disconnect the 7P connector from
the actuator.
|
4. | Check actuator operation by connecting
power and ground according to the table. To prevent damage to the actuator,
apply battery voltage only momentarily.
|
1. | Remove the rear door trim. (Refer to the BD group - "Rear door") |
2. | Remove the rear door module. |
3. | Disconnect the 7P connector from
the actuator.
|
4. | Check actuator operation by connecting
power and ground according to the table. To prevent damage to the actuator,
apply battery voltage only momentarily.
|
1. | Remove the trunk lid trim panel. (Refer to the BD group - "Trunk lid") |
2. | Disconnect the 3P connector from
the actuator.
|
3. | Check actuator operation by connecting
power and ground according to the table. To prevent damage to the actuator,
apply battery voltage only momentarily.
|
1. | Remove the front door trim panel. (Refer to the BD group - "Front door") |
2. | Remove the front door module. |
3. | Disconnect the 7P connector from
the actuator.
|
4. | Check for continuity between
the terminals in each switch position when inserting the key into the door
according to the table.
|
1. | Remove the rear door trim panel. (Refer to the BD group - "Rear door") |
2. | Remove the rear door module. |
3. | Disconnect the 7P connector from
the actuator.
|
4. | Check for continuity between
the terminals in each switch position according to the table.
|
1. | Remove the trunk lid trim. (Refer to the BD group - "Trunk lid") |
2. | Disconnect the 3P connector from
the actuator.
|
3. | Check for continuity between
the terminals in each switch position according to the table.
|
Rheostat. Repair procedures
Inspection
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the engine coolant temperature sensor
connector (A).
...
Checking the coolant level
WARNING
Removing radiator
cap
Never attempt to remove the radiator
cap while the engine is operating
or hot. Doing so might lead
to cooling system and engine
damage. Also, hot ...