Inspection
1. | Check the continuity between
the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.
|
2. | Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch. |
3. | If there is no continuity when
a 50kPa (0.50kgf/cm², 7.25psi) is applied through the oil hole, the switch
is operaing properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.
|
Replacement
When the receiver first arrives for replacement:
1)
It will be in Virgin
State.
2)
It wi ...
Immobilizer system (if equipped)
Your vehicle may be equipped with an electronic engine immobilizer system to
reduce the risk of unauthorized vehicle use.
Your immobilizer system is comprised of a small transponder in the ignition ...
Knock Sensor (KS). Description and Operation
Description
Knocking is a phenomenon characterized by undesirable vibration
and noise and can cause engine damage. Knock Sensor (KS) is installed on the
cylinder block and senses engine knockin ...