Removal and Installation
1. | Remove the front muffler (B)
after disconnecting the oxygen sensor connector (A).
|
2. | Remove the catalytic converter
& center muffler assembly (B) after disconnecting the oxygen sensor connector
(A).
|
3. | Remove the main muffler (A).
|
4. | Installation is the reverse order
of removal.
|
Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
eng ...
Illuminated ignition switch
Whenever a front door is opened, the ignition switch will illuminate for your
convenience, provided the ignition switch is not in the ON position. The light will
go off immediately when the igni ...
Seat Heater Switch. Schematic Diagrams
Circuit Diagram
...