Kia Optima: Measurement Method
| 1. |
These are the dimensions measured
when the measurement points are projected into the reference plane, and
are the reference dimensions used for body alterations. |
| 2. |
If the length of the tracking
gauge probes is adjustable, make the measurement by lengthening one probe
by the amount equivalent to the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the
actual linear distance between measurement points, and are the reference
dimensions for use if a tracking gauge is used for measurement. |
| 2. |
Measure by first adjusting both
probes to the same length (A=A').
|
Check the probes and gauge itself to make sure there is no free
play. |
|
| 1. |
Measurements should be taken
at the hole center.
|
1.
Basically, all measurements in
this manual are taken with a tracking gauge.
2.
When a measuring tape is used,
check to be sure there is no elongation, twisting or ...
See also:
Inspection
Speed Operation Check
1.
Remove the connector (A) from
the wiper motor.
NO
Description
NO
Description
...
Multimedia Jack. Schematic Diagrams
Circuit Diagram
...
Engine compartment
2.4L Engine
2.0L Engine
1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake/clutch* fluid
reservoir 4. Air cleaner 5. Fuse box 6. Positive battery terminal 7. Negative
battery term ...
General