Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures on this page. If in doubt, we strongly recommend that you have a competent technician or towing service jump start your vehicle.
✽ NOTICE
Use only a 12-volt jumper system. You can damage a 12-volt starting motor, ignition system, and other electrical parts beyond repair by use of a 24-volt power supply (either two 12-volt batteries in series or a 24- volt motor generator set).
WARNING - Battery
Never attempt to check the electrolyte level of the batey as this may cause the battery to rupture or explode causing serious injury.
WARNING - Battery
Seat Heater Switch. Schematic Diagrams
Circuit Diagram
...
Replacement
Hood Assembly Replacement
•
When removing and installing
the hood, an assistant is necessary.
...
Receiver-Drier. Repair procedures
Replacement
1.
Remove the condenser, and then
remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :20~25N.m
(2.0~2.5kgf.m, 14.5~18.2lb-ft) ...