Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing.
|
|
| 1. |
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~
17.4 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And
Exhaust System” in EM gro ...
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina
and is installed both upstream and downstream of the Manifold Catalytic Converter.
The sensor output voltage varies in ...
See also:
The Importance of Using Safety Belts
There are four very important reasons to use safety belts even with an air bag
supplemental restraint system. They:
help keep you in the proper position (away from the air bag) when it inflates. ...
Necessary Inspections
Fluid levels, such as engine oil, engine coolant, brake/clutch fluid, and washer
fluid should be checked on a regular basis, with the exact interval depending on
the fluid. Further details are pro ...
Troubleshooting
Trouble Shooting
Ignition System
Symptom
Suspect area
Remedy
Engine will not start or is hard to start (Cranks OK)
Ignition lock switch
...
Removal
Heated Oxygen Sensor (HO2S). Description and Operation