Kia Optima: Installation
• |
Install the component with the specified
torques. |
• |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
• |
Apply the engine oil to the O-ring. |
|
• |
Insert the sensor in the installation hole
and be careful not to damage. |
|
• |
Be careful not to damage the sensor housing
and the connector. |
• |
Be careful not to damage the O-ring.
|
|
1. |
Installation is reverse of removal.
Camshaft position sensor installation bolt:9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
|
|
•
DON’T remove the camshaft position sensor
while the engine is running or right after engine is turned
of ...
Description
Knocking is a phenomenon characterized by undesirable vibration
and noise and can cause engine damage. Knock Sensor (KS) is installed on the
cylinder block and senses engine knockin ...
See also:
Front Seat
WARNING - Driver’s Seat
Adjusting the driver’s seat with the vehicle in motion could cause loss
of control and a serious accident.
Do not allow anything to interfere with the normal posi ...
Installation
1.
Install the balance shaft chain.
(Refer to Lubrication system in this group)
2.
Install the crankshaft chain
sprocket (B) and the timing chain oil jet (A).
...
Repair procedures
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the throttle body
and connect a vacuum pump to the nipple on the throttle body.
2.
Chec ...