Kia Optima: Installation
• |
Install the component with the specified
torques. |
• |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
• |
Insert the sensor in the installation hole
and be careful not to damage.
|
|
1. |
Installation is reverse of removal.
Manifold absolute pressure sensor installation
bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor
connector (A).
...
Description
Intake Air Temperature Sensor (IATS) is included inside Manifold
Absolute Pressure Sensor and detects the intake air temperature.To calculate precise air quantity, correction of the ai ...
See also:
3 Point Rear Center Belt
To fasten the rear center belt
1. Slowly pull the tongue plates out from the retractor.
2. Insert the tongue plate (A) into the open end of the buckle (C) until an audible
“click" is heard, ...
Reassembly
Thoroughly clean all parts to be assembled.Before installing the parts,
apply fresh engine oil to all sliding and rotating surfaces.
...
Additional Programming for Rolling Code Devices
For any rolling-code-equipped device; follow the steps below after completing
the "Programming" section. A second person may make the following steps easier.
1. Locate the "learn&quo ...