Kia Optima: Installation
1. |
Install the key lock cylinder. |
2. |
Install the key warning switch
and key Illumination. |
3. |
Install the key warning/immobilizer
connector. |
4. |
Connect the ignition switch connector
after Install the ignition switch. |
5. |
Install the wiper switch. |
6. |
Install the steering column shrouds. |
7. |
Install the driver crash pad
lower panel. |
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the driver crash pad lower
panel.(Refer to the BD group - "Crash pad")
3.
Rem ...
1.
Disconnect the ignition switch
connector (A) and key warning switch connector (B) from the steering column.
2.
Check for continuity between
the ter ...
See also:
Use of MTBE
Kia recommends avoiding fuels containing MTBE (Methyl Tertiary Butyl Ether) over
15.0% vol. (Oxygen Content 2.7% weight) in your vehicle.
Fuel containing MTBE over 15.0% vol. (Oxygen Content 2.7% w ...
Anti-Lock Brake System (ABS) Warning Light
This light illuminates
when you start the engine. The light will go off if the ABS is operating normally.
Also, this light comes on if the key is turned to ON, and then goes off in 2-3 seconds
i ...
Removal
•
Use fender covers to
avoid damaging painted surfaces.
•
To avoid damaging the
...