Kia Optima: Installation
1. |
Reassemble the steering wheel
remote control switch after connecting the connector. |
2. |
Reassemble the steering wheel. |
3. |
Reassemble the driver airbag
module.
Make sure the steering remote control switch and the airbag module
connectors are plugged in properly. |
|
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the driver airbag module.
(Refer to the RT group)
3.
Remove the steering wheel.
(Refe ...
Troubleshooting
Symptom
Possible cause
Remedy
Tachometer does not operate
Cluster fuse (10A) blown
Check for short and replac ...
See also:
Air Bag Warning
This warning light will
remain on for approximately 6 seconds each time you turn the ignition switch ON.
If the system does not operate as described or if the light comes on while the vehicle
is ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the RCV control solenoid valve connector.
3.
Measure resistance between the valve terminals 1
...
Installation
1.
Install the power window switch
module.
2.
Install the door trim panel after
reconnecting the relevant connectors
...