Kia Optima: Installation
| 1. | Installation is the reverse of removal. |
| 2. | Tighten the HECU mounting bolts and nuts to the specified torque. |
| 3. | After installation, bleed the brake system.(Refer to ABS bleeding) |
Removal
1.
Turn the ignition switch OFF.
2.
Remove the air duct (B) and air
cleaner assembly (A).
3.
Remove the ECM connector (B)
and the arrange the ...
Front Wheel Speed Sensor. Components and Components Location
Components
1. Front wheel speed sensor connector
2. Front wheel speed sensor
...
See also:
Inspection
1.
Measure the pressure of high
pressure line by measuring voltage output between NO.1 and NO.2 terminals.
2.
Inspect the voltage value whether
it is sufficie ...
Fuel Filler Cap. Description and Operation
Description
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which seals the fuel filler.
After the gasket on the fuel filler cap and t ...
Check Engine (Malfunction Indicator) Light
This indicator light
is part of the On Board Diagnostic System which monitors various emission control
system components. If this light illuminates while driving, it indicates that a
potential p ...
Copyright © www.kiopman.com 2024