Kia Optima: Installation
1. |
Remove the ignition key from
the vehicle. |
2. |
Disconnect the battery negative
cable and wait for at least three minutes. |
3. |
Install the seat belt pretensioner
with bolts (B, C).
Tightening torque:Bolt
B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
|
|
4. |
Connect the seat belt pretensioner
connector (A). |
5. |
Install the upper anchor bolt.
Tightening torque:39.2
~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
|
|
6. |
Install the center pillar trim.
(Refer to the Body group- Interior trim) |
7. |
Install the door scuff trim.
(Refer to the Body group- Interior trim) |
8. |
Insert the seat belt to the anchor
pretensioner.
Make sure the lock pin is connected in properly. |
|
9. |
Reconnect the battery negative
cable. |
10. |
After installing the seat belt
pretensioner, confirm proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
1.
Disconnect the battery negative
cable, and wait for at least three minutes before beginning work.
2.
To remove the seat belt anchor
pretensioner (C), keep on push ...
Description
Front seat belt anchor pretensioner operates as well as belt pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on fron ...
See also:
To fasten the front lap/shoulder belt
1. Grasp the buckle and tongue plate.
2. Slowly pull the lap/shoulder belt out from the retractor.
3. Insert the tongue plate into the open end of the buckle until an audible “click”
is heard, ...
Component Location (2)
1. FOB holder
2. Door outside handle
3. Trunk lid open switch
4. FOB key
...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...