Kia Optima: Installation
1. |
Remove the ignition key from
the vehicle. |
2. |
Disconnect the battery negative
cable and wait for at least three minutes. |
3. |
Tighten the curtain airbag mounting
bolts and nuts.
Tightening torque:
Bolts: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Nuts: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.5 ~ 4.3 lb-ft)
|
•
|
Never twist the
airbag module during installation. If the airbag module
is twisted, it may not operate as designed. |
|
|
4. |
Connect the curtain airbag connector. |
5. |
Install the roof trim. (Refer
to the Body group- Interior) |
6. |
Reconnect the battery negative
cable. |
7. |
After installing the curtain
airbag (CAB), confirm proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
1.
Disconnect the battery negative
cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim. (Refer
to the Body group- Interior)
...
Airbag Disposal
Special tool required
Deployment tool 0957A-34100ABefore scrapping any airbags or side airbags (including
those installed in vehicle to be scrapped), the airbags or si ...
See also:
Repair procedures
Inspection
Front Door Lock Actuator Inspection
1.
Remove the front door trim.
(Refer to the BD group - "Front door")
2.
Remove the front door module.
...
Use high quality ethylene glycol
coolant
Your vehicle is delivered with high quality
ethylene glycol coolant in the cooling
system. It is the only type of coolant that
should be used because it helps prevent
corrosion in the cooling ...
Tire sidewall labeling
This information identifies and
describes the fundamental characteristics
of the tire and also provides
the tire identification number (TIN)
for safety standard certification. The
TIN ca ...