Kia Optima: Installation
Be sure to install the harness wires so they will not pinch or interfere
with other parts. |
• |
Do not open the lid of
the side airbag cover. |
• |
Make sure that the airbag
assembly cover is installed properly. Improper installation may
prevent the proper deployment. |
|
1. |
Remove the ignition key from
the vehicle. |
2. |
Disconnect the battery negative
cable and wait for at least three minutes. |
3. |
Install the new seat back assembly.
(Refer to the Body group - Seat)
|
4. |
Install the front seat assembly.
(Refer to the Body group - Seat)
|
5. |
Recline and slide the front seat
forward fully, make sure the harness wires are not pinched of interfere
with other parts. |
6. |
Reconnect the battery negative
cable. |
7. |
After installing the side airbag
(SAB), confirm proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
The side airbag cannot be disassembled from the seat back assembly, so replace
the seat back assembly when replacing the side airbag. ...
Description
Curtain airbags are installed inside the headliner (LH and RH) and protect the driver
and passenger from danger when side crash occurs. The SRSCM determines deployment
of curtain airb ...
See also:
Instrument panel fuse replacement
1. Turn the ignition switch and all other
switches off.
2. Open the fuse panel cover.
3. Pull the suspected fuse straight out.
Use the removal tool provided in the
engine compartment f ...
Side impact air bag
Your vehicle is equipped with a side impact air bag in each front seat. The purpose
of the air bag is to provide the vehicle's driver and/or the front passenger with
additional protection ...
Climate control air filter
The climate control air filter installed behind the glove box filters the dust
or other pollutants that come into the vehicle from the outside through the heating
and air conditioning system. If ...