Kia Optima: Installation
1. |
Remove the ignition key from
the vehicle. |
2. |
Disconnect the battery negative
cable from battery and wait for at least three minutes before beginning
work. |
3. |
Place the passenger airbag on
the crash pad and tighten the passenger airbag mounting bolts.
Tightening torque:8.0 ~
12.0 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
4. |
Install the heater duct to the
crash pad. |
5. |
Install the crash pad. (Refer
to the Body group- crash pad) |
6. |
Tighten the passenger airbag
crash pad mounting bolts.
Tightening torque:
8.0 ~ 12.0 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
7. |
Connect the passenger airbag
harness connector to the SRS main harness connector. |
8. |
Reinstall the glove box housing.
(Refer to the Body group - crash pad) |
9. |
Reconnect the battery negative
cable. |
10. |
After installing the passenger
airbag (PAB), confirm proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
1.
Disconnect the battery negative
cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to the Body group- crash p ...
Description
The Side Airbags (SAB) are installed inside the front seat and protects the driver
and passenger from danger when side crash occurs. The SRSCM determines deployment
of side airbag by ...
See also:
Removal
Rear Combination lamp (Outside)
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the rear combination lamp
cover (A).
3.
Replace the ...
Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications
Direct control VFS[T/CON]▷ Control type : Normal low type
Control Pressure kpa(kgf/cm², psi)
9.81~500.14(0.1~5.1,1.42~72.54)
Curren ...
Schematic Diagrams
Schematic Diagram
CanisterThe Canister is filled with charcoal and absorbs evaporated
fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn
into the intake manifold b ...