Kia Optima: Installation
1. |
Remove the ignition key from
the vehicle. |
2. |
Disconnect the battery negative
cable from battery and wait for at least three minutes before beginning
work. |
3. |
Connect the clock spring harness
connector and horn harness connector to the clock spring. |
4. |
Set the center position by setting
the marks between the clock spring and the cover into line. The mark (▶◀)
should be matched by turning the clock spring clockwise to the stop and
then 2.0 revolutions counterclockwise.
|
5. |
Install the steering wheel column
shroud and the steering wheel. (Refer to the Steering System group- Steering
Column and Shaft) |
6. |
Connect the Driver Airbag (DAB)
module connector and horn connector, and then install the Driver Airbag
(DAB) module on the steering wheel. |
7. |
Connect the battery negative
cable. |
8. |
After installing the airbag,
confirm proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
B. |
Make sure horn button
works. |
|
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace the airbag
module with a new one.
...
Description
The passenger airbag (PAB) is installed inside the crash pad and protects the front
passenger in the event of a frontal crash. The SRSCM determines if and when to deploy
the PAB.
...
See also:
Component Location (1)
1. Buzzer
2. RF receiver
3. Smart key unit
4. Interior antenna 1
5. Interior antenna 2
6. Trunk antenna
7. Bumper antenna
...
Inspection
Brake Booster
1.
Inspect the check valve in the
vacuum hose, intensifier and the connecting section.
...
Windshield Washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 2-3 cycles.
Use this function when the windshield is dirty. The spray and wiper ...