Kia Optima: Installation
• |
Do not turn the ignition
switch ON and do not contact the battery cable while replacing the
front impact sensor. |
|
1. |
Install the new front impact
sensor. |
2. |
Tighten the front impact sensor
mounting nut.
Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
3. |
Connect the front impact sensor
connector. |
4. |
Install the radiator mounting
bracket.
Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
|
|
5. |
Tighten the radiator upper hose
bolt. |
6. |
Reconnect the battery negative
cable. |
7. |
After installing the Front Impact
Sensor, confirm proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
•
Removal of the airbag
must be performed according to the precautions/ procedures described
previously.
...
Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each
center of the front door module (LH and RH) and two SIS which are installed at each
center pillar nea ...
See also:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and
5 [B1/S1].
...
Description
The Electronic Throttle Control (ETC) System consists of
a throttle body with an integrated control motor and throttle position sensor
(TPS). Instead of the traditional throttle cable, an Accele ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the ventilation hose (A) from the fuel
tank air filter. ...