Kia Optima: Installation
1. |
Remove the ignition key from
the vehicle. |
2. |
Disconnect the battery negative
cable and wait for at least three minutes before beginning work. |
3. |
Install the SRSCM with the SRSCM
mounting nuts.
Tightening torque:7.0 ~
9.0 N.m (0.7 ~ 0.9 kgf.m, 5.2 ~ 6.7 lb-ft)
|
Use new mounting bolts when replacing the SRSCM after a collision.
When installing the SRSCM bolt, install the ground wire (B) with
a bolt as indicated above picture.
|
|
4. |
Connect the SRSCM harness connector. |
5. |
Install the floor console. (Refer
to the Body group - console) |
6. |
Reconnect the battery negative
cable. |
7. |
After installing the SRSCM, confirm
proper system operation:
A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable and wait for at least three minutes before beginning work.
3.
Re ...
After replacing the SRSCM with a new one, the “Variant Coding” procedure must be
performed.
1.
On SRSCM variant coding
...
See also:
Intake Air Temperature Sensor (IATS). Description and Operation
Description
Intake Air Temperature Sensor (IATS) is included inside Manifold
Absolute Pressure Sensor and detects the intake air temperature.To calculate precise air quantity, correction of the ai ...
Air cleaner
Filter replacement
It must be replaced when necessary, and
should not be washed.
You can clean the filter when inspecting
the air cleaner element.
Clean the filter by using compressed air. ...
Components (3)
1. Vaccum hose
2. Tube mounting braket
3. Check valve
4. Intensifier
...