Kia Optima: Installation
1. |
Installation is the reverse of
removal. |
After replacement or reinstallation procedure of the valve body assembly,
must perform procedures below.
• |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
• |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
|
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
Description
Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure inside
the torque conver ...
See also:
Component location
1. Driveshaft (LH)
2. Driveshaft (RH)
1. Driveshaft (LH)
2. Circlip
3. Inner shaft bearing bracket assembly
4. Circlip
5. Driv ...
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the head lamp assembly.
(Refer to the head lamp)
3.
Remove the head lamp leveling
ac ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the connector (A), and then remove the
sensor (B).
...