Kia Optima: Installation
1. |
Installation is the reverse of
removal. |
After replacement or reinstallation procedure of the valve body assembly,
must perform procedures below.
• |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
• |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
|
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
Description
The output speed sensor is a vital unit that measures the rate of rotation of the
transaxle's turbine shaft and output shaft, and delivers the readings to the TCM.
The sensor prov ...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
Manual transaxle
...
Manual Antenna
Your car uses a manual stainless steel antenna to receive both AM and FM broadcast
signals. Pull up the antenna using your fingers, as shown in the drawing.
✽ NOTICE
Before entering an au ...