Kia Optima: Installation
1. |
Installation is the reverse of
removal. |
After replacement or reinstallation procedure of the valve body assembly,
must perform procedures below.
• |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
• |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
|
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
Description
Input speed sensor is a vital unit that measures the rate of rotation of the input
shaft inside the transaxle and delivers the readings to the TCM. The sensor provides
critical input ...
See also:
Rear Door. Components and Components Location
Components
1. Rear door trim
2. Rear door belt inside weatherstrip
3. Rear door trim seal
4. Rear door module
5. Rear door panel
6. Rear door side molding
7. Rear do ...
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.
Horn Relay Inspection
1.
...
Turbo Charger. Repair procedures
On-vehicle Inspection
Turbocharger Diagnostic Flow
If any problem related with turbocharger, such as lack of engine power, poor acceleration,
abnormal engine noise or oil leaks, ma ...