Kia Optima: Installation
| 1. |
Installation is the reverse of
removal. |
|
After replacement or reinstallation procedure of the valve body assembly,
must perform procedures below. |
| • |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
| • |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
| • |
Perform TCM learning
after replacing the valve body to prevent slow transaxle response,
jerky acceleration and jerky startup. (Refer to "Automatic transaxle
control system (Repair procedures)" in this group) |
|
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
See also:
Speedometer
The speedometer indicates the forward speed of the vehicle.
ODOMETER/TRIPMETER
You can choose the odometer, tripmeter A and tripmeter B by pressing the mode
selection button. ...
Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is
seen. Make this adjustment before you start driving.
WARNING - Rear visibility
Do not place objects in the rear seat ...
Installation
1.
Install the wiper motor.
2.
Install the crank arm.
Tighting torque:24.5 ~
26.4Nm (2.5 ~ 2.7, kgf.m, 18.0 ~ 19.5 lbf.ft)
...
Removal
Clutch & Brake