Kia Optima: Installation
• |
Install the component with the specified
torques. |
• |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
• |
Apply engine oil to the valve O-ring.
|
|
1. |
Installation is reverse of removal.
CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
|
|
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the OTS (A).
3.
Disco ...
Description
Fuel Pressure Regulator Valve is installed on the high pressure
fuel pump and controls fuel flow flowing into the injectors in accordance with
the ECM signal calculated based on var ...
See also:
Using CD Player
1. CD Button
If the CD is loaded, turns to CD mode. If no CD, it displays “No Media” for 3
seconds and returns to the previous mode.
2. 1 Button (RANDOM)
Press this button for less than 0.8 sec ...
Components(Without EPB)
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting and test procedure
as follows. Compare the system condition with normal condition in the table below
and i ...