Kia Optima: Installation
• |
Install the component with the specified
torques. |
• |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing.
|
|
1. |
Installation is reverse of removal.
Rail Pressure Sensor Installation:
18.0 ~ 22.0 N.m (1.8 ~ 2.2 kgf.m, 13.3 ~ 16.2 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Release the residual pressure in fuel line (Refer
to “Release Residual Pre ...
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance with
the ECM control signal which is calculated by ...
See also:
Control System Composition
Fault DiagnosisFeatures a fail-safe mechanism that prevents dangerous situations
from developing in the event of a transaxle failure. The limp home mode engages
if the transaxle malfunctions. ...
Removal
Front Speaker
1.
Remove the front door trim panel
and speaker connector.(Refer to the BD group - "Front door")
2.
Remove the front speaker (A)
after loos ...
Cleaning
1.
Make sure the ignition switch and all accessories
are in the OFF position.
2.
Disconnect the battery cables (negative first).
3.
...