Kia Optima: Inspection (With GDS)
| 1. | Check BCM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. |
| 2. | If diagnosis is required on the multifunction switch, select model and "BCM". |
| 3. | To consult the present input/output
value of BCM, "Current DATA". It provides information of BCM input/output
conditions of power supply, turn signal/brake lamp, headlamp, door, locks,
outside mirror, wiper, auto-light and transmitters etc.
|
| 4. | To perform compulsory operation
on BCM input factors, select "ACTUATION TEST".
|
Inspection
Lighting Switch InspectionWith the multifunction switch in each position, make
sure that continuity exists between the terminals below. If continuity is not as
specified, replace the multi-functio ...
Removal
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
3.
...
See also:
Description
The SMART KEY system is a system that allows the user to access and operate a vehicle
in a very convenient way. To access the vehicle, no traditional key or remote control
unit is needed.The user ...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Specifications
Specifications
Direct control VFS[35R/C]▷ Control type : Normal low type
Control Pressure kpa(kgf/cm², psi)
500.14~9.81(5.1~0.1,72.54~1.42)
Curren ...
Copyright © www.kiopman.com 2024