Initialization and diagnosis sequence by using GDS equipment.
Below content summarize the procedure for A/S using GDS.
No. |
Procedure |
1 |
Locate vehicle to flat plane |
2 |
Tire check |
3 |
IGN1 ON |
4 |
Head lamp Low Beam ON |
5 |
Connection with diagnostic tool |
6 |
Initial command by diagnostic tool |
7 |
Clear DTC Code |
8 |
IGN1 OFF → ON |
9 |
Re- Connection with diagnostic tool |
10 |
Checking of HLLD output value as 15% and DTC Code |
11 |
HLLD actuating by diagnostic tool command |
12 |
Head lamp mechanical Initial Aiming |
|
1. | Select the vehicle model and
"Head lamp leveling".
|
2. | GDS can operates actuator forcefully,
input/output value monitoring and self diagnosis.
|
3. | To perform functional test on
AHLS outputs, select "Actuation Test".
|
4. | Select " Parameter setting &
Zero position Initial".
|
5. | Confirm that AHLS operate forcefully
in "Head lamp leveling" menu.
|
6. | To check the DTC of the head lamp leveling system, select "Diagnostic trouble codes" |
Removal
•
Use fender covers to
avoid damaging painted surfaces.
•
To avoid damaging the
...
Heating and air conditioning
1. Start the engine.
2. Set the mode to the desired position. To improve the effectiveness of heating
and cooling :
- Heating: - Cooling:
3. Set the temperature control to the desired position.
...
Inspection
1.
Check signal waveform of Input
& output speed sensor using the GDS.
Specification: Refer to "Signal
Wave Form" section.
...