Kia Optima: Inspection
Throttle Position Sensor (TPS)
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Start the engine and measure the output voltage of
TPS 1 and 2 at C.T. and W.O.T.
Specification:
Refer to “Specification”
|
|
3. |
Turn the ignition switch OFF and disconnect the scantool
from the DLC. |
4. |
Disconnect the ETC module connector and measure the
resistance between the ETC module terminals 1 and 2.
Specification:
Refer to “Sensor Resistance”
|
|
ETC Motor
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the ETC module connector. |
3. |
Measure resistance between the ETC module terminals
3 and 6. |
4. |
Check that the resistance is within the specification.
Specification:
Refer to “Specification”
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the resonator and the air intake hose (Refer
to “Intake And Exhaust ...
See also:
Tilt steering
Tilt steering allows you to adjust the steering wheel before you drive. You can
also raise it to give your legs more room when you exit and enter the vehicle.
The steering wheel should be positione ...
Adjustment
Use gauges and testers to adjust correctly the parts to standard values correctly. ...
Limp home (override) procedure
When you turn the ignition switch to the ON position, if the immobilizer indicator
() goes off after blinking 5 times, your
transponder equipped in the ignition key is out of order. You cannot sta ...