Kia Optima: Inspection
2. |
Disconnect the intake actuator
connector. |
3. |
Verify that the actuator operates
to the recirculation position when connecting 12V to the terminal 3 and
grounding terminal 7. |
4. |
Verify that the intake actuator
operates to the fresh position when connecting in the reverse.
1. -
2. –
3. Fresh
4. 5V (Vcc)
|
5. Feedback Signal
6. Sensor Ground
7. Recirculation
|
|
5. |
If the intake actuator is not
operated well, substitute with a known-good intake actuator and check for
proper operation. |
6. |
If the problem is corrected,
replace the intake actuator. |
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the crash pad.(Refer
to BD group - "Crash Pad")
3.
Disconnect the Intake actu ...
See also:
Description
Network ConfigurationThe Network of the SJB(Smart Junction Box) consists of Low
speed CAN as shown in the following figure.
Termination ResistorThe cluster has CAN termination resistor. It is p ...
Air Bag Warning
This warning light will
remain on for approximately 6 seconds each time you turn the ignition switch ON.
If the system does not operate as described or if the light comes on while the vehicle
is ...
Air cleaner
Filter replacement
It must be replaced when necessary, and
should not be washed.
You can clean the filter when inspecting
the air cleaner element.
Clean the filter by using compressed air. ...