Kia Optima: Inspection
| 1. | Measure terminal-to-terminal resistance of the blower resistor. |
| 2. | measured resistance is not within
specification, the blower resistor must be replaced. (After removing the
resistor)
|
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the main crash pad lower
cover (A).
3.
Disconnect the blower resistor
connector ...
See also:
If the engine doesn't turn over or
turns over slowly
1. If your vehicle has an automatic
transaxle, be sure the shift lever is in N
(Neutral) or P (Park) and the emergency
brake is set.
2. Check the battery connections to be
sure they are clean ...
Installation
1.
Install the wiper switch.
2.
Install the steering column upper
and lower shrouds.
...
Line Pressure Control Solenoid Vale. Schematic Diagrams
Circuit Diagram
...
Copyright © www.kiopman.com 2024