Kia Optima: Inspection
2. |
Manually operate the control
switch and measure the voltage of blower motor. |
3. |
Select the control switch to
raise voltage until high speed.
Specification
Fan
|
Motor Voltage
|
Manual
|
First speed
|
3.8 ±0.5V
|
Second speed
|
5.0 ±0.5V
|
Third speed
|
6.2 ±0.5V
|
Fourth speed
|
7.4 ±0.5V
|
Fifth speed
|
8.6 ±0.5V
|
Sixth speed
|
9.8 ±0.5V
|
Seventh speed
|
11.0 ±0.5V
|
eighth speed
|
Battery
|
*AUTO COOLING: Auto speed (4.5V~B+)
*AUTO HEATING: Auto speed (4.5V~11.0V) |
4. |
If the measured voltage is not
specification, substitute with a known-good power mosfet and check for proper
operation. |
5. |
If the problem is corrected,
replace the power mosfet. |
1.
1. Disconnect the negative (-)
battery terminal.
2.
Remove the main crash pad lower
cover (A).
3.
Disconnect the power mosfet connector
...
See also:
Owner’s Responsibility
NOTICE
Maintenance, Service and Record Retention are the owner’s responsibility.
You should retain documents to show proper maintenance has been performed on
your vehicle in accordance with the sc ...
Operation of the rear parking assist system
Operating condition
This system will activate when backing up with the ignition switch ON.
The sensing distance while the rear parking assist system is in operation
is approximately 120 cm (4 ...
Tire terminology and definitions
Air Pressure: The amount of air
inside the tire pressing outward on
the tire. Air pressure is expressed in
pounds per square inch (psi) or kilopascal
(kPa).
Accessory Weight: This means the
...