Kia Optima: Inspection
2. |
Disconnect the connector of temperature
control actuator. |
3. |
Verify that the temperature control
actuator operates to the hot position when connecting 12V to the terminal
3 and grounding terminal 7. Verify that the temperature control actuator
operates to the cool position when connecting in the reverse.
[Drive]
1. -
2. -
3. Cool position
4. Sensor ground
|
5. Feedback signal
6. 5V (Vcc)
7. Hot position
|
|
4. |
Check the voltage between terminals
4 and 5 (Drive). Specification
Door position
|
Voltage(4-5)
|
Error detecting
|
Max. cooling
|
0.3 ± 0.15V
|
Low voltage :0.1V or less
|
Max. heating
|
4.7 ± 0.15V
|
High voltage :4.9V or more
|
[Passenger]
1. -
2. -
3. Cool position
4. Sensor ground
|
5. Feedback signal
6. 5V (Vcc)
7. Hot position
|
|
5. |
Check the voltage between terminals
4 and 5 (Passenger). Specification
Door position
|
Voltage(4-5)
|
Error detecting
|
Max. cooling
|
0.3 ± 0.15V
|
Low voltage :0.1V or less
|
Max. heating
|
4.7 ± 0.15V
|
High voltage :4.9V or more
|
It will feedback current position of actuator to controls.
|
6. |
If the measured voltage is not
specification, substitute with a known-good temperature control actuator
and check for proper operation. |
7. |
If the problem is corrected,
replace the temperature control actuator. |
1.
Disconnect the negative (-) battery
terminal.
2.
Using the screwdriver, remove
the side cover (A).
3.
Loosen the mounting screws and
th ...
See also:
Adjustment
Glass Adjustment
•
Check the glass run channel
for damage or deterioration, and replace them if necessary.
...
Removal
In case of removing the high pressure fuel pump,
high pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by ...
Rear safety belts
Two kinds of belts are provided:
Lap/shoulder belts for people who sit on the outboard sides of the rear
seat.
A lap belt for people who sit in the center of the rear seat.
Rear Lap/Should ...