1. | Measure the pressure of high
pressure line by measuring voltage output between NO.1 and NO.2 terminals.
|
2. | Inspect the voltage value whether
it is sufficient to be regular value or not.
|
3. | If the measured voltage value is not specification, replace the A/C pressure transducer. |
Installation
1.
Install the key lock cylinder.
2.
Install the key warning switch
and key Illumination.
3.
Install the key warning/immobilizer
connector.
...
Inspection
Speedometer
1.
Adjust the pressure of the tires
to the specified level.
2.
Drive the vehicle onto a speedometer
tester. Use wheel chocks (A) as appropriate.
...
Defroster
CAUTION
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window.
✽ NO ...