Kia Optima: Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1. |
Turn the ignition key to the
"ON" position. |
2. |
Cover the front sensor to stop
functioning. |
3. |
Shine a light at the rear sensor. |
4. |
The ECM should be darkened as
soon as the rear sensor detects the light.
If this test is performed in daytime, the ECM may be darkened as
soon as the front sensor is covered. |
|
5. |
When the reverse gear is engaged,
the ECM should not be darkened. |
6. |
When heading lights to both the
front and rear sensors, the ECM should not be darkened. |
1.
Remove the mirror wiring cover
(A).
2.
Disconnect the mirror connector
(B) and remove the mounting screw (A).
3.
Slide the ...
See also:
Rheostat. Repair procedures
Inspection
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
...
Installation
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable from battery and wait for at least three minutes before beginning
work.
...
SS-A Solenoid Valve(ON/OFF). Specifications
Specifications
ON/OFF Solenoid Valve(SS-A, SS-B)▷ Control type : Normal low type
Control pressure kpa(kgf/cm², psi)
490.33(5.0, 71.12)
Internal ...