Kia Optima: Inspection
| 1. |
With the washer motor connected
to the reservoir tank, fill the reservoir tank with water.
|
Before filling the reservoir tank with water, check the filter for
foreign material or contamination. if necessary, clean the filter. |
|
| 2. |
Connect positive (+) battery
cables to terminal 2 and negative (-) battery cables to terminal 1 respectively. |
| 3. |
Check that the motor operates
normally and the washer motor runs and water sprays from the front nozzles. |
| 4. |
If they are abnormal, replace
the washer motor.
NO
|
Description
|
NO
|
Description
|
1
|
GND
|
2
|
Washer (+)
|
|
Washer Fluid Level Sensor Switch
| 1. |
Disconnect the negative(-) battery
terminal. |
| 2. |
Drain the washer fluid less than
650 cc. |
| 3. |
Check for continuity between
the No. 1 and No.2 terminal in each float position. There should be continuity
when the float is down.
There should be no continuity when the float is up. |
| 4. |
If the continuity is not as specified,
replace the washer fluid level switch.
|
-
When servicing the washer
pump, be careful not to damage the washer pump seal.
-
Do ...
See also:
Chart 5
...
MAX A/C MODE
When you select the MAX A/C mode (switch indicator illuminates) while the fan
speed is on, it will be set the system automatically as follows;
- the air conditioning system will be turned on.
- ...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
Removal