Kia Optima: Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.
HL : Head lamp low beam
P : Head lamp passing switchTurn Signal Switch
With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.
Inspection (With GDS)
1.
Check BCM input/output specification
of multifunction switch using the GDS. If the specification is abnormal,
replace the lamp or wiper switch.
2.
If diagnosis is ...
See also:
Battery replacement
When replacement is necessary, use the following procedure.
1. Using a screwdriver, loosen the screw on the backside of the transmitter then
use a thin tool to pry open the transmitter.
2. Disas ...
Emergency Trunk Safety Release
Your vehicle is equipped with an emergency trunk release cable located inside
the trunk inside of the right tail light. If someone is inadvertently locked in
the trunk, when pulled, this cable w ...
Tachometer
The tachometer indicates the approximate number of engine revolutions per minute
(rpm).
Use the tachometer to select the correct shift points and to prevent lugging
the engine and/or overrevvin ...